Configuration Example: RIPng
Figure 13-1 illustrates the network topology for the configuration that follows, which shows how to configure IPv6 and RIPng using the commands covered in this chapter.
Figure 13-1 Network Topology for IPv6/RIPng Configuration Example
Austin Router
Router>enable |
Moves to privileged mode |
Router#configure terminal |
Moves to global configuration mode |
Router(config)#hostname Austin |
Assigns a hostname to the router |
Austin(config)#ipv6 unicast-routing |
Enables the forwarding of IPv6 unicast datagrams globally on the router |
Austin(config)#interface fastethernet0/0 |
Enters interface configuration mode |
Austin(config-if)#ipv6 address 2001:db8:c18:2::/64 eui-64 |
Configures a global IPv6 address with an EUI-64 interface identifier in the low-order 64 bits of the IPv6 address |
Austin(config-if)#ipv6 rip TOWER enable |
Creates the RIPng process named TOWER and enables RIPng on the interface |
Austin(config-if)#no shutdown |
Activates the interface |
Austin(config-if)#interface fastethernet0/1 |
Enters interface configuration mode |
Austin(config-if)#ipv6 address 2001:db8:c18:1::/64 eui-64 |
Configures a global IPv6 address with an EUI-64 interface identifier in the low-order 64 bits of the IPv6 address |
Austin(config-if)#ipv6 rip TOWER enable |
Creates the RIPng process named TOWER and enables RIPng on the interface |
Austin(config-if)#no shutdown |
Activates the interface |
Austin(config-if)#exit |
Moves to global configuration mode |
Austin(config)#exit |
Moves to privileged mode |
Austin#copy running-config startup-config |
Saves the configuration to NVRAM |
Houston Router
Router>enable |
Moves to privileged mode |
Router#configure terminal |
Moves to global configuration mode |
Router(config)#hostname Houston |
Assigns a hostname to the router |
Houston(config)#ipv6 unicast-routing |
Enables the forwarding of IPv6 unicast datagrams globally on the router |
Houston(config)#interface fastethernet0/0 |
Enters interface configuration mode |
Houston(config-if)#ipv6 address 2001:db8:c18:2::/64 eui-64 |
Configures a global IPv6 address with an EUI-64 interface identifier in the low-order 64 bits of the IPv6 address |
Houston(config-if)#ipv6 rip TOWER enable |
Creates the RIPng process named TOWER and enables RIPng on the interface |
Houston(config-if)#no shutdown |
Activates the interface |
Houston(config-if)#interface fastethernet 0/1 |
Enters interface configuration mode |
Houston(config-if)#ipv6 address 2001:db8:c18:3::/64 eui-64 |
Configures a global IPv6 address with an EUI-64 interface identifier in the low-order 64 bits of the IPv6 address |
Houston(config-if)#ipv6 rip TOWER enable |
Creates the RIPng process named TOWER and enables RIPng on the interface |
Houston(config-if)#no shutdown |
Activates the interface |
Houston(config-if)#exit |
Moves to global configuration mode |
Houston(config)#exit |
Moves to privileged mode |
Houston#copy running-config startup-config |
Saves the configuration to NVRAM |