Setting Up the Lab
You can use any combination of routers as long as you fulfill the topology diagram outlined in Figure 1-1. It is not compulsory to use the same model of routers.
Frame Relay DLCI Information
Only DLCIs indicated in Figure 1-2 should be mapped on the routers.
)
Figure
1-2 Frame Relay DLCI Diagram
Routing Protocol Information
Use Figure 1-3 to configure routing protocols for the exercises to follow.
)
Figure
1-3 Routing Protocol Information
BGP Information
Use Figure 1-4 to configure BGP.
Cabling Instructions
Use Tables 1-1 and 1-2 for cabling all devices in your topology. It is not a must to use same type or sequence of interface. You may use any combination of interface(s) as long as you fulfill the requirement.
)
Figure
1-4 BGP Information
Table 1-1 Cabling Instructions (Ethernet)
|
Ethernet Cabling |
Switch1 |
|
R2-ethernet0/0 |
Port 1 |
|
R3-fastethernet0/0 |
Port 2 |
|
R4-fastethernet2/0 |
Port 3 |
|
R5-ethernet0 |
Port 4 |
|
R6-ethernet0/0 to VLAN6 |
Port 5 |
|
R6-ethernet0/1 to pix |
Port 6 |
|
Pix-inside-ethernet1 |
Port 7 |
|
Pix-outside-ethernet0 |
Port 8 |
|
continues |
|
|
IDS-control-interface |
Port 9 |
|
IDS-sniffing-interface |
Port 10 |
|
AAA server |
Port 11 |
Table 1-2 Cabling Instructions (Serial)
|
Back-to-Back Cabling |
DTE-End |
DCE-End |
|
R1-to-frsw* (to R2/R3) |
R1-serial2/0 |
R6-serial1/0 |
|
R1-to-frsw* (to R5) |
R1-serial2/1 |
R6-serial1/1 |
|
R1-to-R4 |
R1-serial2/2 |
R4-serial3/0 |
|
R2-to-frsw* (to R1/R3) |
R2-serial1/0 |
R6-serial1/2 |
|
R3-to-frsw* (to R1/R2) |
R3-serial1/0 |
R6-serial1/3 |
|
R5-to-frsw* (to R1) |
R5-serial0 |
R6-serial1/4 |
|
*frsw = Frame Relay Switch R6 |
|
|