Changing Codecs Using the CLI
If you want to change codecs, enter the following commands using the CLI:
Router(config)# ephone 1 |
Enters the ephone 1 configuration mode. |
Router(config-ephone)# codec g729r8 |
Specifies the G.729 codec for ephone 1. |
Router(config-ephone)# ephone 2 |
Enters the ephone 2 configuration mode. |
Router(config-ephone)# codec g729r8 |
Specifies the G.729 codec for ephone 2. |
Router(config-ephone)# end |
Returns to the CLI privilege exec program mode. |
Figure 2-18 shows the call statistics on the IP Communicator after the codec has been changed.
Figure 2-18 Call Statistics After the Codec Has Been Changed